Prefix-less commands handled by the primary system.
- UNIT_ID [n]:
- 0 <= n < 256. Lists or sets the unit ID.
- INFO:
- Lists all key general session information.
- SERIAL_NUMBER [s]:
- Lists or sets the unit serial number.
- SERIAL_TAG [s]:
- Lists or sets the unit serial tag.
- VERSION:
- Lists the hardware and firmware versions.
- POWER OFF:
- Powers off the device.
- POWER FLASH <ON/OFF>:
- Sets whether or not the power light should flash.
- BATTERY_VOLTAGE:
- Lists the current battery voltage. VOLTAGE is an alias.
- TEMPERATURE:
- Lists the current battery temperature.
- CURRENT:
- Lists the battery current.
- ACCUMULATED CURRENT:
- Lists the accumulated battery current. ACC_CURRENT is an alias.
- ALERT VOLUME [value]:
- Lists or sets the volume for alert tones. value is a real valued number in the 0 to 1.0 range.
- RUN_LEVEL:
- Lists the main systemm run level.
- BATTERY SHUTDOWN [value]:
- Lists or sets the shutdown threshold for the battery, in volts. value should be a real valued number from 0 to 5.0.
- SYNC_CANCEL_ON_SHUTDOWN <ON/OFF>:
- Sets whether or not to cancel the sync process when the unit wants to shut down.
- TEST:
- Runs test code.
- HEARTBEAT_TIMER [value]:
- Lets you choose the heartbeat timeout. It is not a CELL command, despite being most relevant to that module, because the heartbeat timeout lives in the global config. value should be a single precision floating point number of at least 1.0, representing the timeout in seconds. If no argument is given, it lists the current setting. The default is 60.0 seconds.
